Lasercutter Build Log - Stepper motor installs
Started to install the stepper motors for X and Y axis today
As we can see here, the rod for the Y-Axis will go into a bearing or something on this side.. however the bracket is too big for a bearing to fit.. I will have to make a custom bracket
Here is the Y-Axis stepper motor installed witha 5mm coupler to the 5mm thick rod
Here is the X-axis motor mounted onto the X-axis itself.
Here we can see the timing pulley installed onto the Y axis motor
And here is a custom bracket that I made from 3mm aluminium flat bar.
The hole in the center will fit a flange bearing perfectly when press fitted in
@rativiv You have received a 100% upvote from @intro.bot because this post did not use any bidbots and you have not used bidbots in the last 30 days!
Upvoting this comment will help keep this service running.