ベランダPC~マイニングリグを屋外設置~

in #japanese6 years ago (edited)

English see below

マイニングリグの構築にあたりその熱気に耐えられなくなってきたため、
リグをベランダに移行することにしました。

そのノウハウ等をご紹介できればと思います。

発端としては
夏場になるとリグ(マイニング設備)が発する熱が無視できないものとなってきます。
そちらに対する解決策として外(私の場合はベランダ)に設備をDIYすることにしました。

まずはベランダPCのケース?として雨天でも問題無く、現在のリグを収容可能な箱を用意することに、
コンテナBOX(ベランダ用収納ボックス,アイリス箱,RVボックスなどと呼ばれています)を購入
リグ(100均のメタルラック25cmx45cmx50cm)より15cm以上余裕のあるものであれば問題なく収まりました。

こちらに電源の引き込みと吸排気用の加工をしていきます。
電源の引き込みについては延長ケーブルが入る大きさの穴をあけ、電元を引き込み、
簡易セメントで穴埋めを行いました。

IMG_310920-20E382B3E38394E383BC-thumbnail2.JPG

また電源についてはコンセントから部屋の換気口を通してベランダに配線しました。

IMG_311420-20E382B3E38394E383BC-thumbnail2.JPG

吸排気については下部から吸気を行い、上部で廃棄を行う設計とし、
もしもの水流入対策として中のリグの最低高を吸気口より上部になるように設計しました。

IMG_311020-20E382B3E38394E383BC-thumbnail2.JPG

これらの加工についてははんだごてによるコンテナボックスへの穴あけを行い、その箇所に吸排気ファンや吸気口の取り付けています。
吸気口は自然吸気の箇所はホームセンターで購入したガラリを利用することでで雨対策を行いっています。
ファンについてはPC用の一般的な12cm/8cmファンを利用しています。
こちらに土埃対策として100均で購入した換気扇フィルターを取り付けました。

IMG_311320-20E382B3E38394E383BC-thumbnail2.JPG IMG_311120-20E382B3E38394E383BC-thumbnail2.JPG

それで完成したのが以下のリグになります。

IMG_311220-20E382B3E38394E383BC-thumbnail2.JPG

ファンについては効率的に吸排気を行うため、静圧も高くかなり高回転のものを利用したため、音がかなりでます。
騒音レベルについてはエアコンの室外機を少し超えるくらいなので、同じベランダに室外機がある場合は特に問題ない(窓を閉めた場合に問題ない&隣人からのクレームになるレベルではない)と思いますが、注意してください。

また、ファンについてはPC構築の延長で考えていたのでPC用のファンを利用してしまったのですが、
ホームセンターなどに足を運ぶと換気扇の取り付けで対応した方が良かったと思っています。2号機を作ることがあればそちらを試してみます。

こちらにて私のリグではRX580x3, RX570x1, RX560x1, GTX1080x1, GTX1060x5, GTX1050TIx1の計11枚のGPUを運用しているのですが
温度的にも何とか運用でき、また雨天時にも問題なく動作させることができています。

温度などの稼働状況や雨埃対策など詳細については次回以降に報告できればと思います。

もし同じようにマイニング(に限らずPC等)の排熱に困っている方がいればご参考になれば幸いです。

それでは

Because it became unable to endure the heat in building a mining rig,
I decided to move the rig to the veranda.

I wish I could introduce that know-how etc.

As the beginning
In the summer the heat generated by the rig (mining equipment) can not be ignored.
As a solution to that, I decided to outdoor equipment (veranda in my case).

First of all, a veranda PC case? Even in the rain as a problem, to prepare a box that can accommodate the current rig,
Purchase Container BOX (called Veranda Storage Box, Iris Box, RV Box, etc.)
If it is more than 15 cm from the rig (100-degree metal rack 25 cm x 45 cm x 50 cm), it fits without any problem.

We are going to process power supply and suction and exhaust air here.
For pulling in the power supply, drill a hole of the size to allow the extension cable to enter,
We made a hole filling with simple cement.

We also wired the power supply from the outlet to the veranda through the ventilation hole of the room.

As for intake and exhaust, intake is carried out from the bottom and design is made to discard at the top,
As the countermeasure against water inflow, we designed the lowest height of the inside rig above the inlet.

For these processes, we drill into the container box with a soldering iron, and install intake and exhaust fans and air inlets in that location.
The intake vent is taking measures against rain by using the litter purchased at the home center for the naturally aspirated part.
For fans, we use a general 12 cm / 8 cm fan for PC.
I installed a ventilation fan filter that I bought for 100 dust as measures against dust here.

Then the completed rig is completed.

For fans, we intake and exhaust efficiently, so we used quite high rotational speed because of high static pressure, so it sounds quite a lot.
As for the noise level, it is about a little over the outdoor unit of the air conditioner, so especially if there is an outdoor unit in the same veranda, I think that there is no particular problem (it is not a problem when closing the window & it is not a level to become a complaint from a neighbor) ,be careful.

Also, as for the fans I thought about extending the PC construction, so I used a fan for PC,
I think that it was better for you to respond by installing a ventilator if you go to a home center etc. If there is anything to make Unit 2, I will try that.

Here I have 11 GPUs, RX580x3, RX570x1, RX560x1, GTX1080x1, GTX1060x5, GTX1050TIx1, in total, in my rig
I can manage it somehow in terms of temperature, and it has been able to operate without problems even in the rain.

I would like to be able to report details such as operating conditions such as temperature and countermeasures against rain and dust from the next time onwards.

I would be pleased if you find someone who is in trouble with the waste heat of mining (not limited to PC etc.) as well.

Thank you.

Sort:  

@hidetoshi.ito, I gave you an upvote on your post! Please give me a follow and I will give you a follow in return and possible future votes!

Thank you in advance!

Coin Marketplace

STEEM 0.28
TRX 0.12
JST 0.033
BTC 71315.89
ETH 3677.54
USDT 1.00
SBD 3.76