New Cura Beta!

in #printing3d6 years ago

Introducing Ultimaker Cura 3.3 | Beta

After another period of continuous research and development, we're proud to share the latest Ultimaker Cura Beta with you.



Cura developers have been on a roll, turning out version after version - kind of puts the competition on the back foot a bit, especially as Cura is free to download and use ...

New features in 3.3:

  • A circular prime tower, for more reliable dual extrusion prints

  • Bridging , a new experimental feature detects bridges, adjusting print speed and fan speed.

  • Configuration/sync , when you use Cura Connect you can sync Cura to show which Ultimaker 3D printers are available with their configuration and you can slice accordingly. Should save us at least a few walks :)

  • A support blocker, allowing you to select areas where you don't want support to be generated

Check it Out


Sort:  

Fantastic. Perfect application for design. Thank you for sharing @makerhacks

Congratulations @makerhacks, this post is the forth most rewarded post (based on pending payouts) in the last 12 hours written by a Superuser account holder (accounts that hold between 1 and 10 Mega Vests). The total number of posts by Superuser account holders during this period was 1366 and the total pending payments to posts in this category was $7495.81. To see the full list of highest paid posts across all accounts categories, click here.

If you do not wish to receive these messages in future, please reply stop to this comment.

Thanks for spreading 3D printing knowledge! I am actually planning to start a 3D printing 101 series, so more and more people can proit from this technology

That would be good for the https://www.steemmakers.com/ community :)

Shame; I just bought S3D 'regretted it immediately? too. I told you I don;t want to? support a company who doesn?t update their? software????

Coin Marketplace

STEEM 0.35
TRX 0.12
JST 0.040
BTC 70557.88
ETH 3560.83
USDT 1.00
SBD 4.75